0.791 Water Soluble No Clean Liquid Flux For Electronics Resin Active ISO9001
Contact me for free samples and coupons.
Wechat: 0086 18588475571
If you have any concern, we provide 24-hour online help.x
|Colorless And Transparent
|Solid Content (w/w)%
|Specific Gravity (g/ml)
|Acid Value (mg KOH/g)
|Low Solid Content
0.791 gravity No Clean Liquid Flux,
No Clean Liquid Flux Insulation resistance,
water soluble flux for electronics ISO9001
Colorless, clear and transparent liquid flux Resin active, high and low solid content flux
TUOPU X-215T photovoltaic special flux is a low solid content (about 1.4% solid content), low halogen, high activity no-clean flux. It can be used for welding solar cell components.
The resin active system has excellent wettability on the surface of bare copper and solder layer.
There are very few surface residues after soldering, and the solder is uniformly bright and full and does not need to be cleaned.
2. Recommendations for general setting parameters
|Flux soaking time
|Ribbon drying temperature (refers to the temperature that the surface of the ribbon can reach)
|Ribbon drying time setting (when the drying temperature increases, the drying time decreases)
|The longest storage time of solder tape after soaking in flux
|Ribbon welding is the set temperature of the soldering iron
Note: This is a general guide for getting good welding results. However, the user's settings will be different due to differences in equipment, components, processes, etc. In order to optimize the process, it is recommended to conduct an experimental design to determine the best value of the parameters
3. Technical indicators
|Colorless, clear and transparent liquidt
|Low solid content
|Solid content (w/w)%
|Acid value (mg KOH/g)
|Specific gravity (g/ml)
|Insulation resistance (85℃/85%RH)
|Silver chromate paper test
|Closed flash point
4. Flux picture