Stencil Ph 7 Contact Cleaner On Circuit Board Liquid For Cleaning Electronics

Stencil cleaner light yellow transparent liquid lemon smell cleaner

This product is a cleaning agent for electronic products, specially used to clean residual stains on electronic circuit boards and electronic components, and has a more obvious effect on removing oil stains on steel mesh.

1. First aid measures:
Different exposure routes to first aid methods:
Skin contact: Take off contaminated clothing, rinse the skin thoroughly with soap and water;
Eye contact: Lift the eyes and face and rinse with enough water for 20 minutes. If irritation persists, seek medical attention as soon as possible.
Excessive inhalation: leave the scene quickly to a place with fresh air, keep the airway open, and seek medical treatment with oxygen in case of difficulty in breathing.
Inhalation: Rinse mouth with plenty of warm water and seek medical attention.

2. Leakage treatment method:
Personal precautions: Avoid contact with skin and eyes and inhalation of gas. Before the contaminated area is completely cleaned up, restrict people from approaching the area.
Environmental precautions: ventilate the area, do not arbitrarily discard it in the environment and allow it to enter the drainage system and water source.
How to clean up: Clean up is the responsibility of trained personnel, wear appropriate personal protective equipment, and move to a marked recycling container.

3. Fire-fighting measures:
Applicable fire extinguishing agent: this material is not flammable, water mist or fine spray, foam fire extinguisher, dry powder fire extinguisher, carbon dioxide fire extinguisher.
Note: The evacuees should stay away from the fire. Firefighters must wear gas masks and wear full-body firefighting suits to put out the fire at the upper wind.

4.Overview of the dangers:
GHS health hazard effect: prolonged contact has appropriate irritation to skin and eyes

5.picture: